top of page

Installing a Soil Moisture Node

Our SDI-12 soil moisture node is plug-and-play with all Aquacheck soil moisture probes.  No configuration is required.

Installation steps:

  • Be sure to first connect the soil moisture probe before powering up the unit.

  • Connect the soil moisture probe to the node by running the cable through the gland. Connect the coloured wires as follows:

    • Gnd = Black wire​

    • Data = Blue wire

    • Power = Brown wire

    • (Note to electricians - remember this is an electronic device and not a 3-phase heavy current motor. Please don't over tighten the electrical connectors ;-)

  • Do be sure to tighten the outside gland nut so that it secures the cable and acts as a strain-relief for the connectors.​

  • Power up the unit by inserting four new size C batteries of a reputable brand. Be sure to observe the correct polarity.  On initial boot you will see two long LED flashes.  (This will be followed by 4 short flashes when the device joins the LoRa network.)

​

Mounting your device in the field:

  • If you need to mount your device on a frame/pole/backing board please do not drill new holes in the enclosure as this will compromise moisture ingress.  Instead please use the existing holes on the four outside corners.

  • Make sure the gland is facing downwards to avoid moisture ingress.

​​

​

​

LoRa SDI-12 Node
LoRa SDI-12 Node
LoRaWAN SDI12 Node
CONTACT

hello@tretower.co.za

+27 (0)72-714-6142

Graaff-Reinet, South Africa.

COMPANY DETAILS

Celula Pty Ltd t/a Tretower Telematics.

Reg. 2012/058409/07

VAT. 4600263273

Importers Code. 21174202

© 2024 Celula Pty Ltd t/a Tretower Telematics. Registered in South Africa 2012/058409/07. VAT 4600263273.

bottom of page